Crie caixas e muito mais com uma cortadora a laser!
A frame for an engraving ; can be either standing or hanging, both in portrait or landscape
style of the fingers
space at the start and end in multiple of normal spaces
height of the bottom lips sticking out (multiples of thickness) FingerHoleEdge only!
space below holes of FingerHoleEdge (multiples of thickness)
extra material to grind away burn marks (multiples of thickness)
width of the fingers (multiples of thickness)
extra space to allow finger move in and out (multiples of thickness)
space between fingers (multiples of thickness)
width of finger holes (multiples of thickness)
width of the visible part of the engraving in mm
height of the visible part of the engraving in mm
thickness of the engraving plate (and any acrylic window you may add) in mm
margin for the engraving plate insertion in mm
width of the frame in mm
radius of the frame outer corners in mm
radius of the frame inner corners in mm
Add a covenring front plate to glue (hiding the finger joints)
Add dummy finger holes and plugs for the unity of the frame (if not covered)
angle of the back support in degrees ; set 0 or negative value to ignore
thickness of the material (in mm) 🛈
burn correction (in mm)(bigger values for tighter fit) 🛈
format of resulting file 🛈
label the parts (where available)
print reference rectangle with given length (in mm)(zero to disable) 🛈
width of tabs holding the parts in place (in mm)(not supported everywhere) 🛈
Add a QR Code with link or command line to the generated output
style for inner corners 🛈
spacing around parts (multiples of thickness [: extra space in mm]) 🛈
print surrounding boxes for some structures 🛈
Gerar Download Save to URL QR Code
This box is a frame for an engraving.
