Lumina Boxes

style of the fingers

space at the start and end in multiple of normal spaces

height of the bottom lips sticking out (multiples of thickness) FingerHoleEdge only!

space below holes of FingerHoleEdge (multiples of thickness)

extra material to grind away burn marks (multiples of thickness)

width of the fingers (multiples of thickness)

extra space to allow finger move in and out (multiples of thickness)

space between fingers (multiples of thickness)

width of finger holes (multiples of thickness)

the angle of arc cuts

the gap between grooves (fraction of the edge length)

alternate the direction of grooves

invert the groove directions

minimum space left and right without grooves (fraction of the edge length)

the style of grooves

the angle of triangular cuts

the width of each groove (fraction of the edge length)

largura interna em mm (a menos que a opção de medida externa esteja selecionada)

profundidade interna em mm (a menos que a opção de medida externa esteja selecionada)

altura interna em mm (a menos que a opção de medida externa esteja selecionada)

altura interna das paredes internas em mm (a menos que a opção de medida externa esteja selecionada)(deixe como zero para usar a mesma altura das paredes externas)

treat sizes as outside measurements 🛈

play between the two parts as multiple of the wall thickness

thickness of the material (in mm) 🛈

burn correction (in mm)(bigger values for tighter fit) 🛈

format of resulting file 🛈

label the parts (where available)

print reference rectangle with given length (in mm)(zero to disable) 🛈

width of tabs holding the parts in place (in mm)(not supported everywhere) 🛈

Add a QR Code with link or command line to the generated output

style for inner corners 🛈

spacing around parts (multiples of thickness [: extra space in mm]) 🛈

print surrounding boxes for some structures 🛈